If no such station exists, it will use "Refuel" as the station name. The refueling stations name is "Refuel L-CCC-L" for a train with type L-CCC-L.Checking Refuel in the trainline or train UI will add a refueling station to the end of the trains schedule, once that train needs refueling and remove it once it is done.Todo: make that description less confusing. (As opposed to going to the station at the number in the schedule) If a line has "Use station mapping" selected, it will try and go to the station with the corresponding number when used with the Signal # or Station # rule. Allows stations to be assigned a number. Additionally it outputs the trains cargo Station Mapping : The # of the station in the schedule where the train is going (set for 1 tick when the train leaves) outputs the position in the trains schedule if there is exactly 1 line Outputs the number set in the mapping or : The lowest fuel in a locomotive of a train (in MJ) : The line number assigned to the trains line, 0 if not on a line : 1 if a train is at the station, 0 otherwise The signal output: Outputs various information about the train currently at the station: If a train should leave when the condition is true, simply set the condition in the train schedule / line to the same as the lamp condition and connect the lamp to the trainstop via red or green wire. The condition does not have to be fulfilled, as long as the train leaves before its waiting time is over it will use the signal. When a train leaves the station because its waiting conditions became true, it goes to the station specified by the signal in the lamps condition. The signal lamp: Only used in combination with the "Signal #" rule. The smart train stop has two additional components compared to a normal train stop Note: If the train leaves due to the waiting time passed, it will always go to the next station. ![]() Last, if neither of the previous are true, the train will proceed to the next station in the line. 2nd, if Station # is set to a valid station #, the train will choose this station. 1st, if Signal # is checked and the signal lamp has a valid station # input to it, the train will choose this station. The station the train will choose to depart to is determined in this order: Station #: The train will go to the station # specified in the text box. Signal #: The train will ignore the normal order of station on the line and travel to the station specified to the signal lamp. use station mapping: Maps the numbers passed via Signal # or Station # to different stations Line #: Outputs the assigned line number at a smart train stop. To rename a line mark one line, type in the new name and click 'rename'.Ĭlicking the rules button opens the UI for line rules. You can delete lines by checking one or more 'marked' checkboxes and then clicking 'Delete marked'. Unassigning a train removes it from the line, but keeps the schedule intact (minus the goto rules) Un/checking the 'active' checkbox will un/assign a train to the line. Shows the number of stations for the lines, as well as the number of trains assigned to the lines. Accessible by opening a locmotives or trainstops GUI. Overview of lines managed by SmartTrains. Save as line: Saves the trains schedule as a line. Displays an overview of the trains schedule and rules The type is used to determine the refueling station for Autorefuel. In this case: 3 wagons (C) with a locomotive (L) at the front and end. Train: Choumiko (L-CCC-L): The name and type of the train.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |